Drip Irrigation Valve Stuck Open

A broken valve can mean water will not shut off automatically. SHUT OFF the main water supply.

Testing Troubleshooting An Electrical Irrigation Valve Wes Tech

Valve seat is damaged.

Drip irrigation valve stuck open. Unscrew the solenoid by turning counter-clockwise cylinder with two wires and make sure the plunger is clean and moves freely. Replace the diaphragm if damaged. May 30 2009.

Continue with the next step. Turns out I had a small screw floating around insid. For easy access in below ground situations.

If the valve fully opens then the problem is NOT the valve the problem is with the wires leading from the controller timer to the valve or possibly the controller is broken. After a few seconds set it to closed. Get your solution here right now.

Air Trapped in the Valve. Since the water flowing through the port is what holds the valve diaphragm closed the valve stays open. It may benecessary to replace the valve body if the seat area is damaged.

If the valve doesnt respond within a. In this video I show you how to take apart a Rain Bird Irrigation Valve and check for any malfunctions. Valve will not open - There are again two main causes of this problem.

The valves may have air trapped in them. A small bubble of air becomes trapped in the tiny water ports of the valve this stops the water from flowing through the port. Loosen all four bolts.

Its also possible that there is debris in the valve which is causing the diaphragm of the valve to remain open. Carefully take the top of the valve body apart and visually inspect the inside of the valve body. Check the valve seat and the diaphragm seating area forpitting and small debris.

Do I need to throttle down the valves by turning the flow control down to reduce the flow coming in so I have a better pressure. In freezing climates your next step will be to install a manual drain valve so that the water can be drained from the pipes between the zone valves and the shut-off valve. Valve pointer would be the direction the water is supposed to flow through the valve.

When this happens try turning the tab or ring on the black solenoid on top of the valve clockwise until the water shuts off. Valves good without any debris. Call us toll-free at 1-800-634-TURF 8873 Monday through Friday from 730AM to 400 PM PST If you are looking for FAQs on troubleshooting Irritrol products click here.

If the problem stems from trapped air then the first thing to do is turn on the main water supply. On three drip lines I have I reduced several outlets now that I have mature plants and trees but the valves stuck open on each line after doing so. Touch the valve solenoid wires to the terminals on your activator.

Once this valve is installed and tested the valve at the meter may be left open for water usage inside the house. This ring or tab sits around the base of each solenoid. If there is debris or something inside the valve carefully flush it out and put it back together again.

I have checked the drip heads and valves are open not sure of valve pointer newbie I know just enough to get me in trouble. Go to the individual valves and use the manual open and close control to set the valve open. Take a cordless drill or screw driver and locate the four bonnet bolts on the top of the valve body.

Just making sure that it is not installed backwards. Opening a valve under pressure is dangerous and you could be injured. Have an irrigation question or problem.

The valve should open.

How To Fix A Automatic Irrigation Valve That Won T Open

Valves Cleaning Debris From An Irrigation Valve Hunter Industries